TTE450 upgrade turbocharger for VW 2.0 TSi T5 / T6
TTE450 hybrid turbocharger based on the series charger in the VW T5 / T6 with 2.0 TSi engine

For the production of the TTE450 upgrade turbocharger, TTE uses a special milled compressor wheel made of high-strength aluminum and very thin blades. It is not only larger than the series part, but also equipped with the extended tip technology. It therefore promotes significantly more air mass and still responds very early. The standard compressor housing is machined with a CNC milling machine so that it can accommodate the new wheel.

The turbine wheel comes from a K16 trunk group and is significantly larger than the part installed in series. In addition, it experiences the tried and tested grinding by TTE, the so-called clipping. The ends of the turbine blades are rounded to a certain contour, which increases the throughput, reduces the load on the turbine and thus reduces the exhaust back pressure. In addition, the manifold ducts in the TTE450 are ported.

The 360 ​​° bearing used ensures a higher load capacity. The standard pressure cell of the wastegate is adapted to the new environmental conditions by equipping it with a stronger spring. Thanks to the TTE brackets, the spring rate can even be further adjusted by the owner, if this is desired or necessary.

Balancing

The extremely precise balance of every TTE turbocharger is a key element for longevity, sound and function, which is why TTE attaches great importance to this process. Each individual component is initially balanced at up to 2800 rpm in several levels. The trunk group is then assembled and dynamically balanced again in several levels at up to 250,000 rpm. At TTE, this process takes place on a VSR (Vibration Sorting Rig) balancing machine.Each turbocharger is supplied with a balancing report that you can clearly assign to your TTE charger using the serial number, and which you can trace at any time with which values ​​your turbocharger left the factory with.

Facts

- Original Borg Warner housing, machined by TTE
- Special, milled TTE compressor wheel
- Original Borg Warner K16 turbine with abrasion
- Enlarged ducts (the manifold seal must be enlarged manually)
- Modified compressor housing with CNC milled inlet
- Optimized bearing and running games
- Reinforced TTE 360 ° motorsport bearing
- Modified pressure
cell - Fuselage group in several levels, dynamically balanced, with protocol
- power of over 450 HP possible
- installation in original position
- developed, produced and built by TTE

The price for the conversion of your series charger is only valid if an operational, undamaged original charger is sent. If the part sent is not suitable for conversion, you will receive a cost estimate after it has been dismantled.

The name of the turbocharger also indicates the maximum performance! As an example, a TTE350 creates approx. 350 hp and a TTE350 + a little more. Often, however, further modifications to the environment, i.e. engine, intake, AGA, etc. are necessary in order to achieve this performance target. Please contact us if you have any questions, we will be happy to help.

The conversion is only possible if an executable, original T5 / T6 2.0 TSi charger is sent in!
 
 

TTE450 upgrade turbocharger for VW 2.0 TSi T5 / T6

€ 1.222,00Prijs
excl. BTW